I built this one from MDF and some oak veneered MDF I had laying around the shop. It fits in the spare tire/storage compartment behind the seat in my El Camino. I will have pics soon of the new one I'm building.
I built this one from MDF and some oak veneered MDF I had laying around the shop. It fits in the spare tire/storage compartment behind the seat in my El Camino. I will have pics soon of the new one I'm building.
This enclosure was designed by stripminer. It features a removeable top and divider to allow it to be changed from sealed to ported. The port is also interchangeable for different tuning frequencies.
This one features cavities on the sides for crossovers and power distribution accessories
Recessed to mount amps
I buillt this one for hodag17 to fit in a corner of his trunk behind the rear seat. The original design credit goes to JC Hoefer. (I modified it a little for this application)
This one fits behind the rear seat facing the tailgate. The amp will be mounted on the "step down" area. (BTW, if you mount your amp on the enclosure be sure to brace the amp mounting surface and/or use thicker material. I also like to use rubber spacers under the amp to isolate it from the enclosure)
This one fits behind the rear seat facing the tailgate also. The amp mounts in the recessed area between the port and the sub (see above concerning mounting amps to enclosures). It will house a 12" ID MAX and a flush mounted US Amps USA-5600X
Finished in black plastic laminate (Formica) with the inside of the port painted black.
Flush trim panel for amp also finished in black Formica.
This one is built from MDF and euro-birch plywood to fit under the rear seat of a Nissan Titan.
Built in 2 sections for a pair of 8's with about .96ft^3 airspace in each section. Can also be built to house (4) 8's or a pair of 8's on one side and an amp rack on the other.
This one was built for 2 Alpine Type R's and features a simple amp rack in the center for a Rockford Fosgate amp. Only had to move the seat forward 1 click.
Shaped like a parallelegram to sit in the passenger side footwell under the dash. Fits an 8" sub.
Fits in the spare tire wheel well.
This 2.7 cu ft sealed common chamber enclosure fits behind the back seat in the trunk facing rearward. It was buit for 3 10" Alpine Type R's. The spare tire was removed and there is still quite a bit of trunk space available.
side view
These were built as a foundation for a pair of fibrglass/carbon fiber enclosures. They will house 12" Polk Momo's in about .90 cu ft.
I'll have pictures soon of the completed Carbon Fiber enclosures.
Here's a few pics of the completed hatch area. I did the foundations for the enclosures, amp rack and trim plate. My friend Brad did the install including the Carbon Fiber and vinyl. It was his first time doing Carbon Fiber and I think he did an excellent job.
1.5 cu ft sealed enclosure for an Illusion Audio ND12 featuring a "step down" amp rack for an Arc Audio Amp and CDT crossovers.
Finished in Charcoal gray carpet to match the trunk. A stealth panel will be added also.
|
|
| |
|
|
||
| previous page |
|
next page |
|
|
||